11
after the wait-to-start indicator turns off. If the
indicator does not turn off, the starter will
automatically crank after 60 seconds.
5. Engine Run Time. Selects between 10, 15,
20, and 30 minute run cycles.
6. Cold Temperature Starting. Allows the
vehicle to automatically start and run every 1,
2, 4, or 12 hours for severe cold weather.
7. Turbo Timer Feature. For vehicles equipped
with a turbocharger, this feature allows the
engine to continue running for up to 6 minutes
after the ignition is turned off, so the turbo has
time to cool down.
8. Black/Red Wire Programming. Selects
between Ground When Running, Factory
Disarm, and Pulsed or Latched Defroster
output. When set for Ground When Running
output, the wire turns on as when remote start
is activated and remains on until remote start
shuts down. When set for Factory Disarm
output, the Black/Red wire pulses on disarm
and remote start to turn off a factory alarm.
When set to Pulsed Defroster output, the wire
pulses 10 seconds after remote starting. When
set to Latched Defroster, the wire turns on 10
seconds after remote starting and remains on
for 5 minutes.
9. Remote Start Input. Sets the number of
pulses required on the Pink wire to activte or
shut down the remote start. This feature is
normally used when adding remote start to
factory keyless entry systems.
10. Tach Locator Feature. The tach wire
locator feature is used to identify a proper tach
wire in the vehicle.
To aid in the locating and testing of a suitable
tach wire, the system’s LED flashes to indicate
presence of a RPM signal. To use this tach
locator feature, program Starter program
feature #10 to On (button 2).
With the engine running and hood pin
disconnected, probe the suspected tach wire
with the Gray/Black wire (tach input).The LED
will begin flashing if the Gray/Black wire is
reading a proper tach signal. If the LED does not
flash, continue testing suspected tach wires
until the correct wire is found. After the
proper tach wire is located and all start module
connections have been made, test the remote
start.
NOTE: pressing any transmitter button while
using the Tach Locator feature will
automatically exit Tach Locator mode. If after
testing the remote start feature it becomes
necessary to locate another tach wire, the Tach
Locator feature must be programmed again.
Convenience Programmable Features
1. Ignition Lock/Unlock. Automatically locks
the doors when ignition is turned on and
unlocks when ignition is turned off.The system
will not lock if any door is open when the
ignition is turned on. Brake/On mode- the
doors will lock after closing all doors and
pressing the brake pedal with ignition on; the
CONVENIENCE PROGRAMMABLE FEATURES
Step Function
Button 1
Button 2
Button 3
Button 4
1.
Ignition Lock/Unlock
Brake/On
On/On
On/Off
Off/Off
2.
Door Lock/Unlock Pulse
1secL/1secUL
3secL/3secUL
1secL/1secULx2 30secL/1secUL
3.
Yellow/Black Wire
Momentary
10s Timed
Latched
Dome Light
4.
Lock on Remote Start
No lock
Lock
5.
Lock on End Start Cycle
No Lock
Lock
6.
Parking Light w/Start
Flashing
Continuous
Off
S series.qxd 9/24/2004 11:08 AM Page 11
