Delay Effects
14
Delay Parameter Adjust
14
Time
14
Tremolo
14
Tremolo Parameter Adjust
14
Description of Controls
15
Front Panel
15
Input Level
15
Mix Level
15
Output Level
15
Signal Level LED
15
Program Select Knob
15
Variations Knob
15
Rear Panel
15
Power
15
Bypass
16
Input (Left/Mono & Right)
16
Output (Left & Right)
16
Troubleshooting
17
Trouble-Shooting Index
17
Specifications
18
CONTENTS
CHAPTER 5
TROUBLESHOOTING
Troubleshooting Index
If you experience problems while operating the DEP, please use the following table to
locate possible causes and solutions before contacting SHOW Product Support for assistance.
Symptom
The Power LED does not
light when the unit is
powered on.
Sound is distorted, Red
"Input" LED is lit
Sound is excessively
noisy, Green "Input" LED
barely is lit.
No audio is heard.
Hum or noise from output.
Unit does not respond to
front panel controls.
Solution
Turn the Mix control to the
left or press the Bypass
Footswitch.
Turn the Output control to
the right.
Try plugging the unit into
another power jack or
different audio cables.
Check that the power cable
is plugged in properly.
Turn down the Input Level
control.
Turn up the Input Level
control.
Turn Output up and reduce
Aux Return level on mixer.
Power down and power up
again.
Cause
No power.
Input level is too high.
Input level is too low
Output level is too low
and Aux Return on mixer
is up full.
Bypass function is on
with Mix turned 100% wet.
Output level is too low.
Ground loop, unshielded
cables.
Unknown software
conflict, cosmic rays, or
static electricity.
17
