www.PyleUSA.com
4
www.PyleUSA.com
5
9.
[MAIN]
Output, connect the active speaker or amplifier.
10.
[POWER]
Power control switch.
11. Converting switch for “stereo channel” and “USB signal”.
12.
[TAPE/CD ]
TAPE/CD signal input.
13.
[UNBAL5/6]
Stereo input.
14.
[PHONES]
Connect an 3.5mm earphone, the socket is supporting stereo
phone plug.
15.
[DSP Select]
Press UP or DOWN button to select from 16 DSP.
16.
[PEAK]
LED indicator light, when the volume of input signal or volume after
adjusting equalizer is too High, the LED indicator light will keep flashing,
please rotate the [GAIN] CONTROLLER counterclockwise to turn down the
volume.
17.
[Output Level Indicator]
This is a stereo signal level indicator configured
with green LED lights (SIG) at the bottom and red LED lights (Peak)at the top
for both the left channel side and the right channel side. Flashing green LED
lights indicate normal input signals. When the red LED lights are flashing, the
MAIN output signal level may need to be lowered by adjusting the monitor
output level control knob.
18.
[PARAMETER]
Control the parameter of the sound effect.
19.
[FX LEVEL]
Effects return to level controller, adjust the volume of effect.
20.
[PHONES LEVEL]
Earphone controller, adjust the volume of earphone.
21.
[MAIN LEVEL]
Fader, adjust the overall volume from [MAIN] output signal.
22.
[DELAY]
Controller, adjust the depth of the reverberation.
23.
[USB LEVEL]
Controller, adjust the volume of USB channel.
24.
[PAN Control]
The PAN control determines the position of the channel signal
within the stereo image. When working with subgroups,you can use the PAN
control to assign the signal to just one output, which gives you additional
flexibility in recording situations.
25.
[CHANNEL FADER]
Adjusts the level of the channal signal. Use these faders
to adjust the balance between the various channels.
MP3 OPERATING INSTRUCTIONS
1.
WIRELESS BT CONNECTION
a.
Press the "MODE " button in order to select the Wireless BT mode, after the
success of the selection, the Wireless BT icon on display is flashing, and
display BT.
b.
Open the Wireless BT for pairing, after the success of the pairing, there will
be a sound prompt.
2.
BUTTON FUNCTION
a.
"
/REC
" button, press first time to pause the playing song, press again to
continue playing.
b.
" " button, short press to play the previous song, long press to reduce
the input volume.
c.
" " button, short press to play the next song, long press to increase the
input volume.
d. [MODE]
Selecting button, switching the functional model, select USB, REC,
BT in order.
3. USB RECORDING OPERATION
a.
Press the "
MODE
" key to select the REC state.
b.
Press the " /REC" button to start recording, the LED screen shows the
recording time, Press the " /REC" button again to pause the recording.
c.
Press the "
MODE
" key back out the recording.
4. COMPUTER SOUND CARD
When connect the computer data cable, it will enter the PC playing states
automatically (The computer will install the driver automatically at the first
connection, need to wait until the installation finish, to play or record)
USB FOR DATA TRANSFER, RECORD AND POWER SUPPLY
USB FOR POWER SUPPLY ONLY
Connected with PC USB port,
Power bank or power socket
to supply power to mixer.
It must meet the following
requirements:
Output voltage:
4. 8V to 5. 2V
Output current:
1A or even more