7
INSTALLATION
3.Mount the car holder to the flexible neck.
Note the labels on the flexible neck.
The arrow labeled
CLOSE
must point
in the direction of the fixture. The
connection closes with a noticeable
clicking sound.
4.Place the holder with the suction head
onto the suction plate (or directly onto
the wind screen) and press the lever on
the suction head downwards. The
suction head will stick itself firmly to
the suction plate.
5.Place the navigation system into the car
holder by placing it initially in the lower
noses and then pressing it down gently
until the holder clicks in.
Connecting The Navigation System In
The Car
When the battery is in a low voltage, you
can recharge it in the car:
1.Plug the jack (1) of the connection cable
into the corresponding receptor at the
bottom of your navigation system.
2.Insert the power adapter (2) now into
the cigarette lighter socket and ensure,
that it will not lose contact while driving.
This could cause a malfunction.
•
Hint:
Remove the power adapter from
the cigarette lighter socket when ending
a trip or when parking the car for a
extended period of time.
Mounting The Navigation Set On A
Bicycle
1.Place the clip (1) and the Retaining Plate
(2) together and fix them to your bicycle
handlebars by pulling them across the
handlebars from below and pushing one
of the rubber rings (3) supplied between
the clip and the handlebars. The flat site
of the support points in your direction. As
the material is elastic, you can care fully
bend open the support, lay it around the
handlebar and push it together again.
2. Place the holder for the navigation system
(4) on the Retaining Plate (2) as illustrated
above. Push the holder for the navigation
system downwards until it clicks in audibly.
Please pay attention that the holder must
only be used in one direction.
3.Fix the complete holding device with the
supplied screw (5) and tighten it slightly
by hand.
4.Now insert the navigation system into the
holder. You must pay attention to a firm
seating of the clip holder.
5. Set the inclination angle by screwing the
bicycle holder in according to your
requirements. Now turn the screws finger-
tight.
Note:
After assembly, protect your
navigation system from dust and dirt using
the storage pocket. The storage pocket
does not protect against rain or moisture.
Take care that the navigation system does
not exposed to moisture. This may
damage the electronic parts.
When you use the navigation system,
make the navigation system upright with
the GPS antenna (13) will get a strong
signal. If the signal is not good, please
adjust the direction of the GPS antenna
to receive the signal.
1
2
3
4
5
1
2
Holder
Suction
plate
Flexible neck
Holder
Holder
