Pyle PLMRDK17, User Manual

Page: 3 / 12

www.PyleUSA.com
3
INSTALLATION
Notes:
• Choose the mounting location
where the unit will not interfere
with the normal driving function of
the driver.
• Before finally installing the unit,
connect the wiring temporarily
and make sure it is all connected
with the unit and works properly.
• Use only the parts included with
the unit to ensure proper
installation. The use of unautho-
rized parts can cause malfunctions.
• Consult with your nearest dealer if
installation requires drilling of
holes or other modifications of the
vehicle.
• Install the unit where it does not
get in the driver’s way and cannot
injure the passenger if there is a
sudden stop, like an emergency
stop.
• If installation angel exceeds 30°
from horizontal, the unit might not
give its optimum performance.
• Avoid installing the unit where it
would be subject to high tempera
ture, such as from direct sunlight,
or from hot air, from the heater, or
where it would be subject to dust,
dirt or excessive vibration.
DIN FRONT-MOUNT
Installation Opening
This unit can be installed in any
dashboard having an opening as
shown:
Installing the unit
Be sure you test all connections first,
and then follow these steps to install
the unit.
1. Make sure the ignition is turned
off, and then disconnect the cable
from the vehicle battery’s negative
(-) terminal.
2. Disconnect the wire harness and
the antenna.
3. Mount the sleeve by inserting the
sleeve into the opening of the
dashboard and bend open the
tabs located around the sleeve
with a screwdriver. Not all tabs will
be able to make contact, so
examine which ones will be most
effective. Bending open the
appropriate tabs behind the
dashboard to secure the sleeve in
place.
30
53mm
182mm
Tabs
Screwdriver
Sleeve
Dashboard