Pyle PL1SN104, User Manual

Page: 13 / 20

www.PyleUSA.com
12
Phenomenon
Normal
Not operating
Remote comtrol
doesn' t work
No or low sound
Inferior quality of
sound; Distortion
of sound
Machine reset by
itself when it is
shut down
Reasons
Fuse of machine power supply and auto
vehicle battery is burnt,
Volatge of power supply is overloaded
Automatic protection system avoids fault
due to illegal operation
Wrong pin assignment ISO connector
Battery is out of power;
Battery is not placed correctly
Disconnection;
Volume setting is low volume; wrong
connection of Silence; Loudspeaker fault;
Volume balance setting bias
Earthing
in
loudspeaker connection
Inferior disc is used;
Loudspeaker does not match impedance
of the machine; Loudspeaker opens circuit.
Connection of ACC and B+ is not correct.
Solutions
Change for fuse of the
cottect types;
Adjust voltage;
Reset the system by pressing the
Resetkey Check the wiring
diagram
Change new battery;
Reinstall battery
Check the connecion; Increase the
volume; Reconnection the silence
wire complied with the installation
instruction; Change for a new
loudspeaker; Adjust the volume
balance setting to middle place;
Keep insulation of loudspeaker
connection
Use genuine discs;
Change a loudspeaker;
Check the connection of loudspeaker.
Check and reconnect ACC and B+
Troubleshooting
Wheel Set
Setting
Connect the steering wheel control cable, and click the corresponding key to
activate the function.
After entering into the steering wheel control interface, then keep pressing
the steering wheel “VOL+” button in your car, at the same time click
“ ”in the interface, it will be selected, then it is finish this setting.
Click other buttons according this method, the steering wheel function can
be used.