Pyle nutrichef PICEM75, User Manual

Page: 7 / 10

www.PyleUSA.com
7
TROUBLESHOOTING
1. Please note, if a power failure occurs due to disconnection of the power cord, or the off power button has
been pushed off during an ice making cycle, then small ice chips may form and lodge in the automatic
shovel causing it to jam. If this occurs, the ice chips may be removed by disconnecting the power cord and
gently pushing the shovel to the rear of the cabinet to remove the ice chips, then restarting.
2. Please restart the ice maker by pressing Stop and then Start. If the Ice shovel does not push the Ice into the
Ice collector after the formed Ice drops from the evaporator finger, then check to see if the water tray is
horizontal or balanced. If not then adjust by pressing the Ice shovel lightly with your finger.
Then re-start the Ice maker.
The compressor works
abnormally with a
Buzzing noise
Water shortage
indicator light is
ON
Conditions for Ice
making cycle is right
but no ice is made.
Illuminates
The voltage is lower than recommended.
Stop the Ice maker and do not restart until the voltage
is normal.
Refrigerant leaks.
Sealed system is blocked.
Call for service
1. Ice block
2. The motor is broken
3. The viewing window is open while the light is strong
1. Clear the ice under the ice making tray, restart the
unit by push the button
ON/OFF
2. Call for service
3. Please always keep the viewing window close when
ice making.
REASONS
SOLUTIONS
REASONS
SOLUTIONS
1. There is no water
2. The pump is full of air
1. Fill with water, wait 3 minutes and press the ON/OFF
button to restart.
2. Open the drain cap, and let several drops water
runs out.
REASONS
SOLUTIONS
REASONS
SOLUTIONS