Pyle nutrichef PICEM75, User Manual

Page: 4 / 10

www.PyleUSA.com
4
OPERATING IN STRUCTIONS
Step 1: Plug the machine into an outlet.
Step 2: Open the water reservoir access door and add water as shown in sketch A. You can also add water
automatically by connecting the unit to a water source as shown in sketch B.
If the unit is on, and you see the indicator, then you need to add water to the water reservoir.
Step 3:
Press the
ON/OFF
button to start the machine.
Step 4:
Water will be pumped into the water tray from the water reservoir automatically, this takes about 30
seconds.
Note:
If no water is pumped into the water tray for over two cycles, and there is enough water in the
reservoir. Then you need to open the drain cap, and let several drops of water run out, then replace the
cap and press the
ON/OFF
button again to restart the unit.
Step 5:
Select the
SMALL
or
LARGE
button to choose the ice size you want.
Step 6:
The ice making cycle begins, and the ice will be frozen onto the evaporator fingers.
Note:
The ice making time depends on the ambient room temperature.
Sketch A
Add Water Manually
Sketch B
Connect the Unit to a Water Faucet
OPEN
Add water manually
A. to water pipe
B. to water faucet
C. to Unit