eNsuRe that the suPPlY Is IsOlateD
BeFORe staRtINg the DC CaBle INstallatION
Mains cable can be totally removed or simply coiled for potential future use.
Connect to DC through a 5 amp inline fuse.
Please ensure correct polarity.
TRANSDUCERS ARE TO BE MOUNTED DIRECTlY TO THE INNER SKIN OF
THE HUll. IF THE HUll IS A SANDwICH CONSTRUCTION PlEASE CONSUlT
A MARINE SPECIAlIST.
1. Once you have located a suitable location for the mounting the transducer, close to the
center line of the hull, paying special attention to be sure that there is enough head room
to replace the floor / deck plate, and that there is suitable access for running the cables
back to the Sonihull controller.
2. Prepare the hull by sanding down the area to ensure a smooth flat surface,
(it is
important that both the hull and the transducer surfaces are flat to ensure the best
possible surface to surface transmission of the transducer pulse)
.
3. Clean the hull and transducer faces to ensure there is no dust or grease.
Summary of Contents for NRG MARINE SONIHULL MONO
Page 1: ...WWW PYIINC COM ...
