+
6 Check whether the fuel cap is straight and tightened properly. Reinstall the
removable tank in the heater (cap down). Close the lid.
C
SETTING THE CLOCK
It is only possible to set the correct time, when the heater is connected to the mains
and not burning. Use the adjustment keys
N
to set the time. First press either of
the two keys to switch on the function (the 4-digit
K
will start blinking). Next,
set the hours using the key on the left (
N
hour) and the minutes using the key on
the right (
M
min.). Press once to increase the value by one step. When you hold
down the key, the value will continue going up, until you release the key again.
After approximately 10 seconds the 4-digit will stop blinking and the setting will
be locked. 5 minutes after switching off the heater, the information on the display
will disappear and the heater will automatically switch into the stand-by position.
When the heater has been unplugged (or after a power failure), the time needs
to be set again.
D
IGNITING THE HEATER
When used for the first time, a new heater may give out a smell for a short while.
You should therefore provide extra ventilation.
Always ignite the heater with the
button
L
. Never use matches or a cigarette
lighter.
Just press the button
L
to ignite the heater. The POWER lamp will start blinking,
indicating that the ignition procedure has started. This will take a short while. Once
the heater is burning, the POWER lamp will remain lit (red). The information display
K
will show two numbers. The light next to them indicates that these numbers
refer to the temperatures (Fig. F). The actual room temperature is indicated below
ROOM, while the temperature setting is indicated below SET. The latter can be
changed with the adjustment keys
(refer to Section E).
Prior to igniting the heater, always check for sufficient fuel in the removable tank.
E
SETTING THE REQUIRED TEMPERATURE
The temperature setting can only be adjusted, when the heater is burning. Use
the adjustment keys
N
to adjust the temperature. First press either of the two
keys to switch on the function (the °C mark
K
will start blinking). Next, adjust the
temperature using the key on the right (
M
min.) to set the temperature to a higher
setting and the key on the left (
N
hour) to lower the temperature. Press once to
increase the value one step. After approximately 10 seconds the °C mark will stop
blinking and the setting will be locked (Fig. F).
The available temperature settings range from 6°C minimum to 28°C maximum.
When the heater has been unplugged (or after a power failure), the temperature
will reset to the factory setting of 20°C.
4
56
F: The required
temperature on the
left, the measured
temperature on the right.
E: When the 4-digit stops
blinking, the setting
has been locked to the
indicated value.
