SJ100 PVA
Revision C (2019)
18 of 26
Select a Recipe
To operate the valve in Manual mode, do the steps below.
1.
Select Manual mode.
2.
Select the
JDX
tab.
3.
Use the up and down arrows to increase or decrease the value for the necessary
valve parameter (Refill, Dwell, Cycles).
4.
Select the
JDX
Hardware
“
Setup
” button to set the valve to open for
disassembly or service. The screen will show a message about the valve.
Figure 12: Manual Mode, Jetter Tab
NOTE: These settings and changes apply only in Manual mode, unless you
select the Apply to Auto “Go” button.
5.
The parameters shown will be used when the “
Purge
” button on the teach
pendant is used, or when the valve is operated in the
Run
tab.
6.
Select
Apply to Auto “Go”
to set all the values and settings shown on this page
for Auto Cycle for the selected program.
7.
Select the
Clean JDX
“
Go
” button to move the valve to the vacuum cup.
