NTP Sync Device
Issue 2 (01 June 2022)
www.pvelectronics.co.uk
- 6 -
Setup Guide:
1. Configure Clock
Setup the clock for GPS reception at 9,600 bps. Don't forget to set your
local offset from GMT (UTC).
2. Connect
Always connect and disconnect whilst the clock is powered off.
Insert the cable into the back of the clock, and the other end of the cable
into the NTP Sync Device. Then power up the clock again.
3.
Configure Device
:
Upon initial power up, the 3 LEDs light briefly and then the blue DATA
LED on the ESP Module will light constantly. This indicates the device is
in Access point mode, which is where you can connect to it as if it were a
Wireless Hotspot.
