PV Electronics WiFi NTP Sync Device Quick Start Manual Download Page 3

Page: 3 / 8

NTP Sync Device

Issue 2 (01 June 2022)

www.pvelectronics.co.uk

- 3 -

Assembly

Check you have all the parts shown above, and then peel off

the protective film from the laser-cut support piece; Note that the
film may be blue, green white, or even clear, but there is a film on

both sides that needs to be peeled off.

2. Soldering the Jack Socket.

Solder a blob of solder to the

pad of the Jack Connector as shown in the picture below.

Summary of Contents for WiFi NTP Sync Device

Page 1: ...NTP Sync Device Issue 2 01 June 2022 www pvelectronics co uk 1 WiFi NTP Sync Device For Nixie Clock ...

Page 3: ...above and then peel off the protective film from the laser cut support piece Note that the film may be blue green white or even clear but there is a film on both sides that needs to be peeled off 2 Soldering the Jack Socket Solder a blob of solder to the pad of the Jack Connector as shown in the picture below ...

Page 4: ... the connector in position and re touch the pad with the soldering iron whilst pressing the connector onto the PCB This will anchor the component and then you can solder the remaining pads 3 Soldering the 4X2 Header Solder the 6X2 female header as shown in the picture below ...

Page 5: ... Issue 2 01 June 2022 www pvelectronics co uk 5 4 Place the plexi support in the cutout slot on the circuit board 5 Push the ESP module into place in the 4X2 header and it should sit in the recess of the plexi support ...