‘FunKlock’
Issue 5 (14 November 2019)
www.pvelectronics.co.uk
- 16 -
4.10 D5 - D8 (3mm Coloured LED)
The LONG lead goes in the hole marked '+'. Put each LED loosely
into its holes, and then place the tube PCB into position. Now you
can push each LED into the matching small hole in the tube PCB.
Turn the PCBs over so you can solder the LEDs in place, ensuring
they are pushed completely into the holes in the tube PCB. The two
PCBs may now be pulled apart for the rest of the assembly.
4.11 C7 (100 nF)
C8 (0.1 F or 0.22 F)
There are arrows on the component that need to be pointing the
same way as the arrows on the PCB. Simply solder the component
in place ensuring the arrows match up. Keep the component as
close to the PCB as possible so it does not prevent the tube PCB
from fitting correctly.
4.12 SET, ADJ (push buttons)
The two push buttons are now soldered onto the main component
side of the PCB.
If you have purchased the Finned Aluminium Case, do not use the
switches supplied with the kit, but the alternative vertical switches
supplied with the case
