128-9487
2 of 4
2
REMOTE STARTING THE VEHICLE
This unit will not start the vehicle if any one of the following situations exist:
The vehicle's hood lid is opened.
The gear shift selector is not in Park.
The brake pedal is depressed.
The safety control switch is in the Off position.
1. To start the vehicle, press and release the Start button two times within
2 seconds. The vehicle will start and remain running for the pre-programmed
run cycle of up to 60 minutes. As a visual indication, the parking lights will flash
or remain on depending on the setting by your installation center.
2. When you arrive at the vehicle, turn the ignition key to the ON position (not the
spring loaded start position), then step on the brake pedal to disengage the
remote starter. The vehicle will continue to run, but now on its own power.
NOTE:
The engine will stop running before the pre-programmed run cycle has
expired if you perform any one of the following functions:
- Press and release Key/Trunk button on the keychain transmitter two
times within 2 seconds
- Depress the brake pedal
- Open the vehicle's hood
- Place the unit in the safety override/disabled mode
PUSH BUTTON LED RECEIVER VALET/OVERRIDE/SAFETY CONTROL
SWITCH
The Push Button LED switch located in the receiver allows you to temporarily
disable the remote starting function of the system. This is recommended whenever
the vehicle is being serviced.
To place the system in the service mode:
1. With the system disarmed/unlocked, and the ignition switch off, Press and
Hold the Push Button, found on the windsheild receiver, in.
2. Turn the ignition switch on, off, on, off, on, off.
3. The LED begins to flash two short flashes followed by one long flash and
continues this pattern until returned to normal mode of operation.
This puts the unit into the R/S Override mode indicating that the remote start
is in the service mode and will not start from RF or any other input Posse or
otherwise.
To Exit R/S Override Mode:
1. With the system disarmed, Press and Hold the Push Button, found on the
windsheild receiver, in.
2. Turn the ignition switch on, off, on, off, on, off.
3. The LED turns off, indicating that the R/S unit is fully functional once again.
NOTE:
The LED on the receiver can be selected/toggled on and off. This feature
is useful if you do not want the LED flashing all the while the vehicle is locked.
To toggle this feature on or off:
1) Turn the ignition switch on then off.
2) Within 5 seconds, Press and hold the receiver's push-button switch for
