PURSUIT DENALI 24, Owner'S Manual

Page: 44 / 132

Denali 24
Electronics Switch
This switch supplies 12-volt electrical current to the electronics.
12-volt Receptacle
Provides electrical current for portable 12-volt equipment.
Windlass Safety Switch
The windlass safety switch is located on the helm switch panel next to the windlass switch. Turn
the safety switch on to activate the windlass control switch and turn it off whenever the windlass
is not in use. This switch is provided to reduce the possibility of accidentally activating the windlass.
It is protected by the type and size circuit breaker recommended by the windlass manufacturer.
Windlass Switch
This switch controls the optional windlass which is mounted to the deck directly above the rope
locker. It is activated by the windlass safety switch and protected by the windlass safety switch
breaker. Please refer to Chapter 11 and the windlass owner's manual for additional information on
the operation of the windlass.
Trim Tab Switch
Located in the helm. This switch controls the trim tab planes located on the transom of the boat. It
is protected by the 12-volt receptacle plug breaker. Please refer to Chapter 2 for detailed
information on the operation of the trim tab controls.
4.3 Electrical System Maintenance
DC Electrical System Maintenance
At least once a year, spray all exposed electrical components behind the helm and in the plugs, with
a protector. Exterior light fixture bulbs should be removed and the metal contact areas coated with
a non-water soluble lubricant like petroleum jelly. The sockets should be sprayed with a protector.
Care must be taken not to get any oil or petroleum jelly on the glass portion of the bulbs as this will
cause the bulb to overheat and burn out.
WHEN REPLACING LIGHT BULBS IN MARINE LIGHT FIXTURES, ALWAYS USE A BULB
WITH THE SAME RATING AS THE ORIGINAL. USING A DIFFERENT BULB COULD CAUSE
THE FIXTURE TO OVERHEAT AND MELT OR SHORT CIRCUIT.
Inspect all wiring for proper support, sound insulation, and tight terminals, paying particular
attention to portable appliance cords and plugs.
Check all below deck wiring to be sure it is properly supported, that the insulation is sound, and
that there are no loose or corroded terminals. Corroded terminals should be thoroughly cleaned
with sandpaper, or replaced, tightened securely and sprayed with a metal and electrical protector.
Inspect all engine wiring.
4-4