PURSUIT C 260, Owner'S Manual, Page: 36 / 124

LS 265
36
4.4 12-Volt DC Panels
BREAKER PANEL
The helm and cockpit switch functions are protected by a breaker panel located below the steering helm. The
breaker panel is equipped with "push to reset" breakers that are protected from the elements by rubber boots.
These breakers are all normally on and cannot be manually turned off. Should one of these breakers trip from
overload, push the breaker plunger inside the boot to reset.
The following are descriptions of the accessories controlled by the helm switches.
HELM SWITCH PANEL
Port/Stbd
The fuel gauge switch panel is located at the helm and allows one fuel gauge
to be sued for both fuel tanks. With the ignition switch on, move the switch
to port and the gauge will show the fuel level in the port fuel tank. Move the
switch to starboard and the gauge will show the fuel level in the starboard tank.
Windlass
This switch controls the optional windlass. It is protected by a circuit breaker
of the type and rating recommended by the windlass manufacturer. See the
Exterior chapter for proper use of the windlass.
Spreader
Activates the spreader lights located on the optional hardtop. These lights
provide additional lighting for the rear of the cockpit.
Depth Sounder
Provides 12-volt current to the depth sounder.
Aft Bilge
Activates the aft bilge pump which is installed in the aft bilge under the fish
box. Depressing the switch will activate the manual pump.
12-Volt Accessory
The switch operates the 12-volt accessory outlets.
Panel
Activates the instrument lighting.
Cockpit
Activates the lights that illuminate the cockpit area.
Hard Top Light
Depressing this switch activates the light mounted underneath the hardtop.
Helm Switch Panel
Helm Breaker Panel