After unpacking, check all parts for possible damage.
Fully charge the battery before first use.
Mount the battery pack using the supplied mounting plate and Velcro
fastener at the location of your choice in the camper.
Make sure there is at least 10 cm clearance around the battery.
Do not install the LiFePO4 battery in an unventilated area, there is a
risk of overheating!
Switch off all loads and charging equipment before you start connecting.
Use proper cabling of sufficient cross-section and correctly dimensioned
terminals and battery terminals. Tighten all connections securely.
Recommended tightening torque for M8 is 9.9 - 14 Nm. Do not use too
great a tightening torque, as this can lead to irreparable damage to the
LiFePO4 battery.
If you use screws to connect consumers instead of the supplied battery
terminals, make sure that these screws are not long than 10mm.
Never use the LiFePO4 battery in locations with
gas or dust explosion hazards or potentially
flammable products.
WARNING!
Figure 3. Difference diameter of + and - pole
11
