P16MI394 - A02 - 04/15 | 15
3. CONNECTION
The electrical installation must comply with local or national regulations. This appliance must be instal-
led by a competent electrician.
• The technical characteristics of your appliance are shown on the data plate located on the side of the
appliance. Please take note of these before any request for After sales service.
• Any interventions on electrical parts must be done by a qualified professional.
• The factory fitted power cable must be connected to the mains by a junction box which will have to
be placed behind the appliance, without putting in a power socket and which will be located at least
250 mm from the floor.
• Supply voltage 230-240V,
• Connect the 3 core cables as follows:
Brown wire = Live
Grey or Blue wire = Neutral
Black wire =
Control Wire (Pilot Wire)
This wire must never be connected to the earth and must be isolated,
• If the supply cable is damaged, it must be replaced by a specific cable. Replacement of this cable must
be done by the manufacturer, their after sales service or people with similar qualifications in order to
avoid any danger.
• RCD of 30mA maximum is compulsary for bathrooms or shower rooms,
4. CONDITIONS OF USE
Refer to the paragraph WARNINgS in point 1. general information
• The heater can be used continuously without any risk.
• For operating the electronic regulation refer to the operating instructions.
5. MAINTENANCE TIPS
Maintenance operations must be done with the heater switched off. Therefore take care the appliance is
off. In order to ensure your heater lasts, we recommend you use the following few tips:
• Use only mild cleaning agents when cleaning and wiping of the radiator is necessary.
• Use a dry cloth (without solvent) for the control unit.
• Use warm soapy water for cleaning the outside walls of the heater (no abrasive or corrosive product).
INSTALLATION AND MAINTENANCE OF YOUR RADIATOR
EN
RETTIG_TINOS_E and PAROS E_4 languages_2015.indd 15
12/05/15 10:23
