Note 5
: 1” (25 mm) long Pan Head Wood Screws (Qty. 4) are NOT required for
test trials. This will avoid any holes being made in door.
PREPARE PŪRLEVE HYGIENIC DOOR HANDLE
2
3
INSTALL PŪRLEVE HYGIENIC HANDLE
INSTALL DOOR HANDLE HARDWARE
1
OPTION - Handle Latch Only (no push button lock)
a
Snap included lock cover (a) from accessories
on the Pūrleve Handle cover (Figure 5).
Ensure the larger of the three snaps matches
the largest of the three holes on handle cover.
a
5
OPTION -
Push Button Lock Option
Insert included Push Button (c) and then Snap
Button Ring (b) into place on the Pūrleve Handle
cover. Ensure the larger of the three snaps
matches the largest of the three holes on handle
cover (Figure 6).
a
b
c
6
b
With fingers, unscrew the Push Button Connector
until almost fully extended (Figure 7).
Shoulder
7
See Note 4.
Install lever and lock housing into
door hole. Ensure the lock housing engages
with the latch prongs and retractor interlocks
with the latch tail (Figure 2).
b
2
d
See Note 5.
Install and tighten 1” (25 mm) Pan
Head Wood Screws through mounting plate
into the door (Qty. 4). If you require a pilot hole
for these screws, make a 7/64” (2.78 mm) hole.
(Figure 4).
4
Install latch with included 3/4” (19 mm) Flat
Head Screws (Qty. 2). The flat edge of the latch
should face the direction the door opens
(Figure 1).
a
1
c
Place the push button connector into the back
side of the Pūrleve Handle through the center
(small end first) by matching the RIB of the
handle with gap in the connector. Ensure the
Push Button Connector drops to the bottom of
the hole (Figure 8).
8
Note 6
: Ensure the Pūrleve Handle is “OFF” until the refill is installed
a
The installed Bored Cylindrical Hardware should
be unlocked. The hardware is unlocked if the
button is extended (Figure 9). To unlock turn
cylinder.
9
c
Install the Pūrleve mounting plate on to the door
hardware with 5/8" (15 mm) flat head wood
screws (Qty. 2). To avoid stripping the screws,
do NOT overtighten. The flat edge of the mounting
plate should face away from the edge of the
door and remain vertical. The flat side of the
mounting plate should face the door and the
bosses of mounting plate should face away
from door (Figure 3).
3
Note 4:
Ensure the Pūrleve LOCK HOUSING does not extend outside the hole
in the door. If it protrudes, the handle will not function properly. DO NOT tighten
outside handle rose until Pūrleve mounting plate has been fastened to Pūrleve
LOCK HOUSING.
p.3
p.4
