5. SETTING OF CONTROL PANEL FOR OPERATION WITH MACH3 PROGRAM
1. Connect control panel using the attached power injector according to diagram shown below.
When connection is correct, LED indicators 18..21 light up. This means that control panel is ON but it has
no connection to NC program.
Fig. 2. Power injector connection diagram
2. Install relevant plug-in for operation of control panel with MACH3 software.
Download archived file of software from www.purelogic.ru/doc/SOFT/PLPendant.zip and run “setup.exe”
file contained in archive. Software installation wizard will open.
Fig. 3. Installation wizard
* - Additional system components such as Microsoft .NET Framework 2.0 distribution kit and Microsoft
Visual C++ 2008 Redistributable Pack must be installed on your system for correct operation of plug-in. If
wizard does not find these components on your system, you will be asked to go to the page using the link
to download and install these components. Plug-in for MACH3 will not function without these
components.
Press “Next”, wizard will offer to perform automatic setting of PC network adapter for correct connection
with control panel (fig.4).
-3-
