PureLink by Dtrovision
78
The "IF" is an initiation command for Input channel general information selection. The
characters and numbers that follow the "IF" command tell the system, which Inputs'
channel information will be requested. The last character “!” is found at the end of a
command code which tells the system to execute the command.
For example, the command code
*255IFI01!
can be interpreted as follows: (*) Starting the command code (255) Router ID is 255
(IF) Input channel general information request on (I01) Input 01 (!) take the command.
For a complete list of command characters and their functions, see examples below.
Example:
Command Codes
Action
*255IFI01!
Check Input Channel 1 Information
IE: Input Extender Source Select
The "IE" is an initiation command for Input Extender source selection. The characters
and numbers that follow the "IE" command tell the system, which Inputs' Extender
source selection will be made. The last character “!” is found at the end of a command
code which tells the system to execute the command.
IE command only applies to the CATx/Fiber Input Board with PM-CT102,103 (CATx)
and PM-FT102,103 (Fiber) Extender Transmitter.
For example, the command code
*255IEI01SP!
can be interpreted as follows: (*) Starting the command code (255) Router ID is 255
(IE) Input Extender source selection on (I01) Input 01 Extender (SP) source to select
VGA (!) take the command. For a complete list of command characters and their
functions, see examples below.
IE: Input Extender Source Select
SP: VGA (PC), SH: HDMI
Example:
Command Codes
Action
*255IEI01SP!
Set Input1 Extender source to VGA
