5
LED STRIP
3:
If using two B90 connectors, line up the red wire side of the power connector with the "+24VDC" marking on the LED strip.
Push the male connector of the LED strip into the female connector of the power connector. If necessary, repeat for the other
LED strip.
4:
If using two Snap & Light connectors, insert the LED strip into the Snap & Light connector so that the "+24VDC" mark on the
strip is aligned with the red wires. Ensure the LED strip contacts align fully with the contact pins. Push the LED strip
completely into the contact pins. If necessary, repeat for the other LED strip.
B90 POWER
CONNECTOR
SNAP & LIGHT
CONNECTOR
Q
5:
Place all connections inside the junction box to avoid dark
spots.
6:
Carefully remove the backing from the LED strip, making
sure not to remove the tape from the strip.
7:
Firmly press down the adhesive portion of the LED strip
onto the channel surface while removing the rest of the
backing, making sure there are no air bubbles that can
cause surface irregularities.
8:
Repeat steps 6 and 7 for the other LED strip.
PAPER
BACKING
LED STRIP
BOTTOM
MOUNT
LED STRIP
R
S
3
4
5
6
7
8
BOTTOM
MOUNT
BOTTOM
MOUNT
BOTTOM
MOUNT
9:
If using one power connector, trim excess LED strip from
other power feeds ONLY at dashed cutting lines and overlap
it with the other soft strip at power connection to avoid dark
spots in the installation.
T
9
OVERLAP
9
EXCESS LED STRIP
