Section Three: Connecting Channel Sections
2:
Align the channel assembly with the Straight Power
Connector and slide into place.
3:
For ends conducting power, push the channel assembly onto
the male pins of the Straight Power Connector until they
are properly mated.
H
3
PINS
3
4:
Secure the channel by tightening the four #4-40 set screws
using a 0.05" Allen wrench.
5:
Repeat steps 2 through 4 for the other end of the Straight
Power Connector.
6:
Install the lenses and optional louvers to the assembled
channel (refer to the instructions provided with the channel).
I
#4-40 SET
SCREW
CHANNEL
STRAIGHT POWER
CONNECTOR
SP
SP1
1:
The Straight Power Connectors physically connect two Nova
Ceiling Modular Channels together and conduct the power
from a remote power supply powering two channels (SP) or
one channel (SP1).
INDICATES 24VDC
POWER FLOW
2
5
G
4
J
7:
Connect the low v24VDC power supply wire to the
red wire of the Straight Power Connector with a wire nut.
8:
Connect the low voltage -24VDC power supply wire to the
black wire of the Straight Power Connector with a wire nut.
9:
If necessary, snap the wire management clip to the
channel to hold the wires in place.
10:
Place all wire nut connections inside the junction box.
11:
Refer to the instructions provided with the channel to
complete the installation.
JUNCTION
BOX
7
8
10
CHANNEL
WIRE
MANAGEMENT
CLIP
9
