2
3
3
PIN
CARRIER
PIN
CARRIER
L-SHAPED
POWER
DUAL CIRCUIT
5
P
2:
Align the male pin carrier with the female connector on the
end of the L-Shaped Power Dual Circuit Connector that will
conduct power.
3:
Push the male pins completely in the female connector of
the L-Shaped Power Dual Circuit Connector and then lift the
carrier up to remove it.
4:
Repeat steps 2 and 3 for the other side of the L-Shaped
Power Dual Circuit Connector.
PINS
4
Q
5
CHANNEL
L-SHAPED
POWER
DUAL CIRCUIT
R
NOTE:
Ensure that additional channel sections are properly
supported using Cirrus Suspension Modular supports.
5:
Align the channel assembly with one end of the L-Shaped
Power Dual Circuit Connector and slide into place.
6:
Push the channel assembly onto the male pins of the
L-Shaped Power Dual Circuit Connector until they are
properly mated.
7:
Secure the channel by tightening the four #4-40 set screws
using a 0.05" Allen wrench.
8:
Repeat steps 5 through 7 for the other end of the L-Shaped
Power Dual Circuit Connector.
9:
Install the lenses and optional louvers to the assembled
channels (refer to the instructions provided with the
channel).
S
8
6
CHANNEL
7
#4-40 SET
SCREW
