SAVE THESE INSTRUCTIONS!
- This product is for indoor locations only.
- The CSDM-LPD connector physically connects two CSDSM-_
or CSDHM-_ Cirrus Suspension Modular Downlight channels
together at 90 degrees apart and conducts the power from
two remote power supplies powering both channels.
IMPORTANT INFORMATION
1718 W. Fullerton Chicago, IL 60614
Ph: 773.770.1195 ● Fax: 773.935.5613
www.PureEdgeLighting.com ● [email protected]
© 2016 PureEdge Lighting. All Rights Reserved.
Doc # 904-CSDM-LPD_01
Installation Instructions for
Cirrus Suspension Downlight Modular
L-Shaped Power Dual Circuit Connector
1
CSDM-LPD-_
4:
Use the 18AWG hole of the wire stripper to remove 1-3/8"
of the outer insulation to expose the braided wire.
5:
Use the 18AWG hole of the wire stripper to remove 1" of
the braided wire making sure not to nick the inner wire
insulation.
6:
Use the 20AWG hole of the wire stripper to remove 1/8" of
the inner insulated wire.
NOTE:
Scan the QR Code to watch the video clip of
the following steps or visit
http://www.edgelighting.com/videos/cxc_connector/
BRAIDED
WIRE
INNER
INSULATION
BARE
WIRE
1/8"
OUTER
INSULATION
1"
3/8"
COAXIAL CABLE
B
COAXIAL
CABLE
4
5
WIRE
STRIPPER
6
4" CANOPY
COAXIAL
CABLES
3
CORD
GRIP
NOTE:
If cable is curled or kinked, straighten by holding between the shaft of a screwdriver and thumb and pulling the cable
through (see inset).
KNURLED
NUT
2" CANOPY
CORD GRIP
ASSEMBLY
COAXIAL
CABLES
A
1:
Split the end of the coaxial cables coming from the L-Shaped Power Dual Circuit Connector.
2:
For the 2" canopy, feed the cables through the knurled nut, 2" canopy and cord grip assembly respectively.
3:
For the 4" canopy, feed the cables through the cord grip of the canopy.
Section One: Installing the Canopy
2
