Strobe Can manual.doc
3/6
Avoid direct exposure to the light from the lamp. The light is harmful to the eye.
Do not attempt to dismantle and / or modify the luminaire in any way.
Electrical connection must only be carried out by qualified personnels.
Before installation, ensure that the voltage and frequency of power supply match the power
requirements of the unit.
It is essential that each unit is correctly earthed and that electrical installation conforms to all relevant
standards.
Do not connect this device to any dimmer pack.
Make sure that the power-cord is never crimped or damaged by sharp edges. Never let the power-
cord come into contact with other cables. Only handle the power-cord by the plug. Never pull out the
plug by tugging the power-cord.
The luminaire can not be used continuously over 15 minutes under maxmum speed. The lamp used
in this projector is a discharge and high voltage lamp. After being switched off don’
t attempt to restart
the projector until lamp has cooled, this will require approx 15 minutes. Switching the lamp on and off
at short intervals will reduce the life of both the lamp and the projector. But occasional breaks will
prolong the life of the lamp and projector.
Never run the luminaire without a lamp.
There are no user serviceable parts inside the unit, do not open the housing and never operate the
unit with the covers removed.
Always disconnect from the mains, when the device is not in use or before cleaning it or
before attempting any maintenance work.
If you have any questions, don’
t hesitate to consult your dealer.
Strobe Speed
Control
Input/Output
Signal Socket
Power Cord
Locking Knob
Bracket
Fixing Hole
Hole for Fixing
Secondary Safety Chain
Front Cover
Safety Chain
Front Cover
This unit has been designed to be hung. Mount the bracket provided on the body of the unit by 2 M6
locking knobs provided, then suspend the unit via its bracket using a M10 size bolt through the fixing
hole. When you want to adjust the angle of the body of the unit, you only loosen the two M6 knobs
carefully and then adjust the angle of the body. After finishing that, it is recommended that you don’
t
forget to retighten the two knobs. Always ensure that the unit is firmly positioned to avoid vibration
and slipping, and always ensure that the structure to which you are attaching the unit is secure and is
able to support a weight of 1.5Kg for each Strobe Can.
For safety the unit and the front cover should have secondary fixing with a safety cable through the
hole as shown in the figure above.
INSTALLING THE UNIT
