planet manual.doc
4/14
Mount the bracket provided on the body of the projector by 2 M6 knobs provided, then suspend
the projector via its mounting bracket using a M12 size bolt and a nut. When you want to adjust
the angle of the body of the projector, you only loosen the two knobs carefully and then adjust
the angle of the body. After finishing that, it is recommended that you don’
t forget to retighten the
two knobs. Always ensure that the projector is firmly positioned to avoid vibration and slipping,
and always ensure that the structure to which you are attaching the projector is secure and is
able to support a weight of 10Kg for each PLANET.
For safety the unit should have a secondary fixing with a safety chain through the fixing hole on
the upper unit, and the safety chain should afford 10 times of the unit’
s weight.
Open the lamp access hatch at the bottom of the projector by loosening the 2 M4 screws as
shown above.
Take out the lamp-bracket from the inside of the projector by loosening the 2 M4 screws.
Insert the lamp in the lamp holder.
Install the lamp-bracket on the position slot well and then tighten the 2 M4 handy screws.
Close the lamp access hatch again, and then tighten the 2 M4 handy screws.
NOTE:
The MSD series are high pressure lamps with external igniters
. Care should always
be taken when handling these lamps. Always read the manufacturers "Instructions for use"
enclosed with the lamp.
INSTALLING THE PROJECTOR
FITTING THE LAMP
