Pure Digital Fiberlink 7235, User Manual

Page: 4 / 12

Optical:
Operating Wavelength ............. 1310 nm; MM or SM
Optical Fiber ............................ 62.5/125 microns MM,
50/125 microns MM or
8-10/125 microns SM
Optical Connector .................... ST
Audio:
Number of Audio
Channels Supported ................. 2, unbalanced
Number of Baseband
Stereo Audio Outputs .............. 1 internal PDP; 1 external
Frequency Response ................. +0/-0.5 dB, 20 Hz to 20 kHz
Input Impedance ....................... >24 k Ohms
Output Impedance .................... <1 Ohm
Maximum Audio Level ............ +10 dBu
THD+N ..................................... 0.005%; 20 Hz - 20 kHz
SNR (A-Weighted) ................... 95 dB
Channel Phase Differential ....... +/-0.1
o
Crosstalk ................................... Min. 95 dB (1 kHz)
External Signal Connectors ...... 2 position RCA jack
Audio to Video Differential
Delay (skew) .............................. <300 uS
4
Number of Baseband
RGBHV Video Outputs ........... 1 internal PDP, 1 external
RGB Format Supported ............ RGB with separate H and V
External Signal Connectors ...... HD-15F
RGB Processing ....................... 24 bits, no compression or scaling
Power: ON: (GREEN) Indicates that correct power has been applied.
Indicator LEDs:
The Pure Digital Fiberlink
®
7235 receiver has four integral indicator
LEDs that are used to monitor the state of the unit.
The status of the LEDs are as follows:
Video: OFF: Indicates no video detected over the fiber and, as a
result, no video present on the output.
BLINKING GREEN: Indicates either H or V sync detected
over the fiber but not both
STEADY GREEN: Indicates both H and V sync detected over
the fiber and, as a result, active video detected by the receiver
unit.
Audio: OFF: Indicates no audio detected over fiber and, as a result,
no active audio detected by the receiver unit.
BLINKING: Indicates audio detected over fiber and, as a
result, active audio detected by the receiver unit.
Tx: OFF: Indicates no optical loop-through output is present.
ON: Indicates optical loop-through output is present.
9