8
Before first use, remove possible manufacturing process residues by boiling 3 full
kettles of water. Dispose this water.
Tip: You can use vinegar or special descaling agents for the first time.
4. Before use for the first time
Make sure that you do not spill any water on the base.
5. Place the jug on the base, and insert the plug in the wall socket. Push down the
on/off switch. The on/off pilot light will illuminate.
1. Turn the jug so that the spout faces away from you.
2. Press the button to open the lid (3).
3. Fill the jug with the required quantity of water (at least 0.6 litres, and a maximum
of 1,7 litres). Never fill the water boiler over the "max". Otherwise the hot water can
spatter out of the base.
ATTENTION
4. Release the button to open the lid.
6. The jug kettle is now switched on, and the water will now begin to heat. The jug
kettle switches off automatically a few seconds after the water has come to the
boil. The on/off pilot light will now extinguish.
7. Remove the jug from the base by the handle, and pour the water out.
ATTENTION
Be carefully you do not contact the hot water. It can cause serious burning wounds
8. When you wish to heat the water without it coming to the boil you can switch off
the jug kettle at any time you require.
9. Remove the plug from the wall socket when you have finished using the jug kettle.
5. Use
The jug kettle is fitted with an overheating safeguard. This will switch off the jug
kettle if it is operated without (sufficient) water. Allow the jug kettle to cool down
for at least 10 minutes before using it again.
6. Overheating safeguard
