8
TAPE TO CTRL ROOM,TAPE TO MIX, FX TO CRTL,
PHONES/CTRL ROOM DIAL AND MAIN MIX
- The buttons
are as follows TAPE to CONTROL ROOM and TAPE TO MIX
You can press any one of these channels to get a signal to
come through to the headphones or to the main mix fader.
Pressing 2 will allow both the signals to come through at the
same time.
PHONES/CONTROL ROOM DIAL -
The dial under the selec-
tor buttons control the signal level of both headphones and the
main monitor outputs.
NOTE :
When you are listening to your headphones for the
first time make sure that the gain control dial is turned fully
anti-clockwise so if the audio signal is too high it does not
damage your hearing.
MAIN MIX FADER
- The MIX FADER sets the final level of the
Mix outputs. This should normally be set close to the ‘0’ mark if
the input GAIN settings have been correctly set, to give maxi
-
mum travel on the fader for smoothest control.
NOTE: Polarity (Phase)
Just as a balanced signal is highly effective at cancelling out unwanted
interference, so two microphones picking up the same signal can cancel out,
or seriously degrade the signal. If one of the cables has the +VE and -VE
wires reversed. This phase reversal can be a real problem if the microphones
become close together for what ever reason. Therefore you should always
take care to ensure that the pins are correctly wired when wiring up your audio
cables.
