Pulse fitness 225F, Maintenance Manual

Page: 10 / 33

WARNING
When installing or adjusting any piece of Pulse Fitness
equipment, DO NOT leave any adjustment devices projecting
which could cause injury to any third party.
3 Installation
3.1 Location
Select a suitable location for the Exercise Cycle before moving it.
The site you choose should meet the following requirements:
A flat, level and clean surface.
Well away from sources of water (or other liquids) or in an area
that is subject to condensation.
NOTE: The 225F Group Exercise Cycle is not suitable for outdoor
use.
3.2 Installation Procedure
Once the Exercise Cycle has been sited you must ensure that it is
stable. If necessary, adjust the height of the front adjustable
suspension feet to compensate for any unevenness in the floor.
Turn the front feet to the left or right to increase or decrease the
height as appropriate, (see Figure B). When satisfied, securely
fasten the locknut up against the Feet Strut. The rear adjustable
suspension feet should be inserted fully into the Feet Strut and
not used for unevenness correction.
To protect the paintwork from sweat, wipe down the metal frame
with a wax/silicone-based polish.
CAUTION
This equipment is heavy! We do not recommend attempting
to lift it without assistance; at least 2 people should lift the
Exercise Cycle when necessary.
To move the Exercise Cycle, hold the handlebars and push
down to get the bike balanced on the front feet caster rollers,
then push or pull to its desired position.
10
Figure B Feet Adjustment
Adjustable
Suspension feet
Locknut