1
1
ASSEMBLY
Attaching Wheels (See fig 1)
•
Parts needed - 2 wheels, 1 axle, 1 hair pin.
•
Raise or tilt pressure so you can slide the wheel axle pin into the wheel, the wheel mounting hole located on the side
of the frame.
•
Secure the wheel assembly by reinserting a hair pin through hole at the end of the wheel axle and pressing until it
locks into place.
•
Repeat process on the other side of the generator to install the second wheel.
Install Handle (See fig 2)
•
Install upper frame (handle) onto the lower frame by sliding the handle over the two upright tubes on the lower frame
and pressing down firmly until the handle is seated and the two detent pins snap in place.
FIG 1
FIG 2
Attaching Upper Gun Hooks and High Pressure Hose Hook (See fig 3)
•
Attach the upper gun hook. Align the upper gun hook with the holes, install two plastic rivets, until the plastic rivets are
snug, press hard with your finger to lock the rivet
,
then install the M6 screw & lock nut, wrench tighten until the nut is
snug, do not over tighten.
•
Attach the high pressure hose hook, install the M6 screw & lock nut, wrench tighten until the nut is snug, do not over
tighten.
FIG 3