2
1.3. Accessories.
For the power supplies are available accessories - fuse blocks and cable adapter. For details
–visit www.pulsar.pl
2. Installation.
2.1. Requirements.
The power supply shall be mounted by the qualified installer having appropriate (required and necessary for a given country)
permissions and qualifications for connecting (operating) low-voltage installations. The power supply shall be mounted in closed rooms,
according to the environment class II, of the normal air humidity (RH=90% max.) and the temperature within the range from -
10°C to
+40°C.
The power supply load balance should be done before installation. During normal operation, the total current of the
receivers should not exceed I=1 A. The maximum battery charging current is 0,3 A. The total current of the rec battery
is max. 1,3 A.
The power supply is designed for a continuous operation and is not equipped with a power-switch. Therefore, an
appropriate overload protection in the power supply circuit should be provided. Moreover, the user should be informed how to
disconnect the power supply unit from the mains supply (usually by assigning an appropriate fuse in the fuse box). The electrical
system shall be made in accordance with applicable standards. In order to meet the LVD and EMC requirements, the rules concerning
power supply, building-in and shielding should be followed accordingly.
2.2. Installation procedure.
1. Before installation, make sure that the voltage in the 230 V power-supply circuit is cut off.
2. Install the power supply.
3. Connect the power supply to the 230 V line. The power supply has to be installed in such way to keep the air flow around the
supply unit.
4. Connect the DC output to the load/loads.
5. Switch on the 230 V supply.
6. Connect the battery in accordance with the markings: +BAT red to 'plus', -
BAT black to 'minus’.
7. Close the enclosure, cabinet, etc. after installing and checking the operation of the power supply.
3. Maintenance.
Any and all maintenance operations may be performed following the disconnection of the power supply from the power
network. The power supply does not require any specific maintenance procedures, however, in the case of significant level of dust, it
should be cleaned with the compressed air.
WEEE designation
The waste electric and electronic equipment worn out may not be disposed of together with
standard household waste. According to the WEEE directive, applicable in the EU, the separate
neutralization methods should be used for electric and electronic equipment.
Pulsar sp. j.
Siedlec 150, 32-
744 Łapczyca, Poland
Tel. (+48) 14-610-19-40, Fax. (+48) 14-610-19-50
e-mail:
