Operation (cont’d)
18
1. Turn off the switches of the device before connecting to the generator.
2. Start the generator.
3. Insert the plug of the device into the receptacle based on the voltage
requirement of the device.
To stop the engine in an emergency, turn the engine switch "OFF".
In order to maintain generator's performance:
Using the Generator Set
Always connect the generator to the ground terminal to prevent
electrical shock.
the ignition button for more than 5 seconds. Doing so may damage the
If electric start does not turn on the generator after three attempts, contact
3. Follow steps 6-7 from the Recoil Start Method
customer support. Repeated attempts could damage the ignition mechanism.
alternator.
Add the watt ratings of all the loads that the generator set will be
powering at the same time. Make sure that total wattage will not exceed
the generator rating.
Using DC Output Terminals
You can use 12V 8.3A DC output to charge automotive batteries. Be sure to
monitor the battery charge time.
Over-charge may cause explosion and injury
1. Connect the positive (red) terminal of the battery to the red (positive)
terminal the 12V 8.3A DC Output Terminal on the front panel
2. Connect negative(black) terminal of the battery to the black (negative)
terminal of the 12V 8.3A DC Output terminal on the front panel (DO NOT
Summary of Contents for PG7500B
Page 1: ...7500 7500B 1 866 591 8921 ...