www.pulsar.pl HPSBOC5012C
8
3.2 Technical outputs
The PSU has indication outputs:
FAC - absence of AC supply output: - OC type output that indicates AC power loss. Under normal status,
with 230V AC supply, the output is connected to ground (L level – 0V). In case of power loss, the PSU will
switch the output into high impedance state hi-Z after approx. 10s.
FAC - absence of AC supply output: - relay output indicating the absence of AC supply. In case of power
loss, the PSU module will switch the relay contacts after approx. 10 seconds.
CAUTION! In Fig.2. the contact set in the potential-free status corresponds to a state with no AC
power (AC power failure).
FPS – technical output indicating absence of DC voltage at the PSU: OC type output indicating the PSU
failure. In normal state (during correct operation) the output is connected to ground (L level – 0V). In case
of absence of DC voltage at the output (e.g. short circuit), the output is switched into high impedance state
– hi-Z.
FLB – technical output indicating battery voltage: OC type output. Under normal status (U
BAT
> 11,5V) the
output is connected to ground (L level – 0V). In case of decrease of battery voltage (U
BAT
< 11,5V) the
output is switched into high impedance state – hi-Z.
Fig. 4. Electrical diagram of OC outputs.
4. Operation and use.
4.1 Overload or short circuit of the PSU output (SCP on)
In case of overload, the output voltage is automatically shut off, and so is the LED indicator. The restoration
of the voltage takes place immediately after the failure (overload) is over.
4.2 Battery-assisted operation.
In case of a main power outage, the device is immediately switched into a battery-assisted operation.
The PSU is equipped with the discharged battery disconnection system. During the
battery-assisted operation, reducing voltage below 9,5V at the battery terminals will cause
battery disconnection.
4.3 Maintenance.
Any and all maintenance operations may be performed following the disconnection of the PSU from the
power supply network. The PSU does not require performing any specific maintenance measures, however, in
case of significant dust rate, its interior is recommended to be cleaned with compressed air. In case of fuse
replacement, use a replacement of the same parameters.
