FRONT PANEL CONTROLS AND INDICATORS
Phase Supply Neons
show when
there is mains voltage at the Datapak.
Output Monitor Neons (Green)
show the status of the output, whether
or not a load is connected.
Fuse Blown Neons (Red)
light when
their channel fuse has blown.
Electronics On/Off switch with built
in indicator neon
controls the power
to the electronics.
Lamp Preheat switch
prevents the lamp filaments from
cooling right down. This prevents the heavy surge currents
that occur when cold filaments are switched on and thus
extends lamp life.
WARNING – FUSING OF INDUCTIVE LOADS
In the unlikely
event of a fault occurring in your Datapak, it is possible that damage
could occur to incorrectly fused transformers or ballasts of inductive
loads if you do not switch off within about one minute of the fault
occurring. Make sure that your inductive loads are fitted with the
lowest value of anti-surge fuse that does not blow in normal use. If in
doubt contact Pulsar. Pulsar cannot be held responsible for damage
to incorrectly fused inductive loads under these circumstances.
Pulsar Pinspots are fully protected by self-resetting solid-state fuses.
IMPORTANT- CAPACITIVE LOADS
may only be Switched by
a Dimming / Switching Datapak. To dim such loads remove all of
their Power Factor Correction capacitors. It is possible to damage
your load if this is not done. Pulsar cannot be held responsible for
damage to capacitive loads under these circumstances.
INTERFERENCE SUPPRESSION
The Datapak has a
comprehensive choke/capacitor interference suppression system
which reduces the level of interference produced to below the levels
required by EN55022, BS800, VDE0875 etc.. However, a small
amount of residual interference always exists with this type of of
equipment, so it is advisable to keep all lighting and mains leads
associated with the Datapak as far away as possible from sensitive
microphone or guitar pick up leads and A.M. radios; by doing this we
do not envisage any problems.
MAINTENANCE
Pulsar Datapaks use the very latest techniques
(pioneered by us) to completely eliminate the need for routine
adjustments. The sophisticated circuits we have developed are self
stabilising against changes in mains voltage, mains frequency, top
and bottom control voltage levels, preheat drift, drifting of component
values, etc.
PORTABLE APPLIANCE TESTING
-
The Datapak may be
safely Earth Bond and Insulation Tested (500V).
STANDARDS
- The Datapak complies with the following
International and National Standards:
Electrical Safety
- IEC65, EN60065, BS415
EMC
- EN50081-1, EN50014, EN55022, EN50082-1
Rack Mounting
- IEC297
Index of Protection
- IP20
Marking Directive 93/68/EEC
- The
DATAPAK
meets
both the EMC Directive 89/336/EEC and the Low
Voltage Directive 73/23/EEC.
GUARANTEE - three years from the date of original purchase. The
guarantee covers defects in manufacturing workmanship and
materials. It is limited to parts and labour. The guarantee becomes
void if the product is: a) misused, b) not used in accordance with the
instructions, c) the cable connections are not made according to our
instructions if the unit is used in damp or wet environments, d) repairs
are made by unauthorised persons, e) the serial number label has
been removed or defaced. Pulsar's maximum liability shall not
exceed the price paid for the product. In the unlikely event of a fault
occurring, do not use without repair. Return the product, with a
description of the fault, to your supplier or direct to Pulsar for
immediate attention.
The following products have been designed to work with and
complement the Pulsar
Datapak
. Please contact us to receive
further details of these superb products!
Digital Control
Product No.
Controller
23000
48 Channel Masterpiece Control Desk
24000
108 Channel Masterpiece Control Desk
20216
216 Channel Masterpiece Control Desk
27216
Masterpiece Replay Unit 216
20054
Minipiece 54 Control Desk
Analogue Control
Product No.
Controller
25200
6 Channel Desk with Master and Flash Buttons
23910
12 Channel Single Preset Desk
23920
18 Channel Single Preset Desk
23900.1
12 Channel Two Preset Desk
23900.2
18 Channel Two Preset Desk
24400
18 Channel Rock Desk Mk2
26000.3
Programmable Touch Panel II
Lanterns
A comprehensive range of stage, rock and effects lanterns, and
PAR36 and PAR46 Pinspots.
19" Racks and Accessories
Product No.
Accessory
25600.2
12U Rack Cabinet
25700
20U Rack Cabinet
26600
29U Rack Cabinet
26700
38U Rack Cabinet
25700.1
20U Rack Door
1, 2, 3 and 4U Blank and ventilation panels also available
Mains Distribution
Product No.
Unit
29600AA
180A Mains Distribution 3U 3 x 60A, 13A Skt
29600AC
180A Mains Distribution 3U 3 x 60A, Schuko Skt
29600AE
As 29600AA but also with CEE17 Inlet
29600AG
As 29600AC but also with CEE17 Inlet
Cables
Product No.
Cable
28200
10m 6 Channel DIN Signal Lead (1 Plug + 1 Skt)
28100.1
25m 6 Channel DIN Signal Lead (2 Plugs)
28100.2
50m 6 Channel DIN Signal Lead (2 Plugs)
21750.1
2m DMX Extension Lead (1 XLR-5 Plug, 1 Skt)
21750.2
2m DMX Extension Lead (1 XLR-5 Plug, 1 Skt)
21750.3
10m DMX Extension Lead (1 XLR-5 Plug, 1 Skt)
21750.4
DMX Line Terminator Plug
DIMENSIONS AND WEIGHTS
Code Unit
Width
Height
Depth Weight
mm
mm
mm
kg
29900.3
12 x 5A Datapak 482.6
533.4
150
11.5
29901.3
12 x 10A Datapak
482.6 533.4 150
12
29902.3
18 x 5A Datapak
482.6 533.4 150
14
29903.3
18 x 10A Datapak 482.6
533.4
150
14.5
29904.3
9 x 20A Datapak 482.6
533.4
150
14.5
OPERATOR INFORMATION
OPERATOR INFORMATION
ACCESSORIES
DATAPAK III
