2
2. Mounting of the ARAS800/1000 rail in the RACK 19” cabinet:
Mount cage nuts for M6 screws in the RACK cabinet, as shown in Figure 2 below, and mount the ARAS rails
(depending on the depth of a RACK cabinet). Make sure that the rail is correctly mounted horizontally and its length
between the front and rear RACK profile is properly adjusted.
Fig.2
3. Mounting of the ARAD-S4 in the RACK 19” cabinet:
After mounting the ARAS rails in the rear of the RACK 19 ", mount the Patch Panel as shown in Figure 3.
Fig.3
Mount the ARAD-S4 enclosure on fully extended ARAS rails using 6xM4 screws (complete with ARAS rails).
Tighten the screws from the inside. Connect the Patch Panel wires as shown in the Fig.4
CAUTION!!! - Pay attention to the correct arrangement of A / B / C / D / E / and F connectors
in the appropriate sockets described on PCB Signal Boards.
Fig.4
