72-910-16 Rev. N
Page 20 of 43
Biocide A
– Force the biocide A control output on or off.
Biocide B
– Force the biocide B control output on or off.
Auto
– Return the control output to normal operation.
On 5 Min
– Energize the control output for five minutes.
Off
– De-energize the control output indefinitely.
Forcing the output to Auto may cause the control output to energize without warning.
7.9 Water Meter Menu
From the Water Meter menu you select what type of water meter the controller is attached to.
Once the meter type has been entered the next screen will ask you for the gallons/liters per
pulse or “K-factor” depending on the meter type. You can also select between gallons or liters
for units of measure and view or reset the water meter totalizer.
Meter Type
– Select between a dry contact or Hall-effect water meter. Once the type is
selected enter the resolution or volume per pulse.
Units
– Select gallons or liters as a unit of measure for water calculations.
Totalizer
– This displays the current amount of water the controller has counted. You
can reset the totalizer from this menu.
7.10 Languages Menu
7.11 Drum Levels Menu
From the Drum Level menu you select how you want the chemical pump control output to
respond to a low drum level indication. Your choices are to allow the pump to continue to run or
have the pump stop when its drum level goes low. There is one drum level input for each pump
control output.
Home Screen
Configure
Language
English
Spanish
Portuguese
Back | Select
Home Screen
Configure
Water Meter
Meter Type
Units
Totalizer
Back | Select
Meter Type
Dry Contact
Hall Effect
Back | Select
