Page 11
Configuring the TM-1327GE Camera
TM-1327GE Software
3.2.1 GUI Features
You can control the following camera functions using the integrated camera software:
•
Shutter Speed and Mode
•
Scan Mode
•
Gain Control
•
Offset Level
•
Memory Pages
•
LUT (Look-Up Table) Control
3.3 Configuring the Internal Frame Grabber
The integrated camera software updates the internal frame grabber settings automatically. In addition,
because the internal frame grabber configuration is independent of the imager configuration, you can
set up (that is, “window”) the internal frame grabber separately, for example, the Image Settings tab in
the integrated camera software. This has the added benefit of reducing unnecessary traffic on the GigE
network, therefore freeing bandwidth for other cameras.
3.4 Modes
This section includes several examples of setup actions available through the camera configuration
dialog box. Note that items 3.4.2 through 3.4.8 are all found under the GigE Camera Software tab of the
configuration dialog, as previously shown in Figure 11.
3.4.1 Check the Current Camera Setting
You can manually send camera commands from the “Port Communication” tabbed dialog shown in
Figure 12. Use the serial port and click the “CR” check box. Enter :RPST and click
Send
to get the
current camera setting. For detailed information about the current camera setting, refer to Table 4 on
page 24.
Summary of Contents for TM-1327GE series
Page 2: ......
Page 4: ......
Page 8: ...Page viii TM 1327GE Series Progressive Scan Camera...
Page 36: ...Page 28 GigE Series Camera Serial Commands TM 1327GE Software...
