ENG
ENG
Operation
If the code received by the card is in the memory, the output relay will be activated.
If there are no relay expansion cards, relay 1 is activated only if the transmitter is in the memory and the
button is the one previously programmed.
If there are relay cards connected and if transmitter button '1' is pressed, relay 1 is activated, if transmitter
button '2' is pressed, relay 2 is activated, and so on until relay 3.
Vario 255 receiver cards are connected to the handling board by means of a connector (5).
Elements List
Connections
1-
Programming/reset button.
1-
220V
2-
Voltage LED
2-
220V
3-
220v connection.
3-
Common relay1
4-
Main board relay and access
4-
Relay 1 Normally Open
Control connection.
5-
Relay 1 Normally Closed
5-
Insertable memory card.
6-
+ 12 Volts Access Control
6-
Relay 1.
7-
- 0 Volts Access Control
7-
Relay 2 connection.
8-
S Signal Access Control
8-
Relay 3 connection.
9-
Option selector
Options (Switches)
I1 Relay 1
ON:
Bistable Relay 1
OFF:
Bistable Relay 1 Normal
I2 Relay 2
ON:
Bistable Relay 2
OFF:
Bistable Relay 2 Normal
I3 Programming via radio
ON:
Permitted Programming Via Radio
OFF:
Programming Via Radio NOT permitted
Programming
Manual programming
Press the programming button (1) for one second. A long beep will sound to indicate that you have entered
in programming. Next press the buttons of the transmitters to be saved. A short beep will be heard with each
button pressed. After 10 seconds without programming, the receiver will exit programming, indicating this
with a series of short beeps.
Transmitter programming via radio
This programming is normally used to add new transmitters to a receiver that is already installed.
You need to have a transmitter already saved in this receiver and for options selector '3' to be ON. Press the
button situated at the back of the transmitter, with the aid of a pen or paper clip. A long beep will be heard,
indicating that you have entered in programming, then press the new transmitters to be saved. After 10
seconds without programming, the receiver will exit programming.
Programming with a portable programmer
To extract or insert the memory card (5), the receiver must be out of programming mode and with the power
supply off, or the memory may suffer variations in its values,
Insert the insertable memory card into the slot in the portable programmer and carry out the desired option
(deleting, saving codes, modifying, etc.)
Deleting the receiver memory
From the receiver all codes are deleted together, not individually.
Press the programming button (1) for 4 second. After the first second a long beep will be heard followed by a
series of short intermittent beeps indicating that the memory has been deleted.
N.B.: With the portable programmer, codes can be deleted individually.
Technical Data
Sensitivity
Better than –-100dbm
Consumption at rest
15 mA
Consumption at max. operation
50 mA
Operating temperature
0ºC to +70ºC
Main Board Relay
10 Amps
Relay expansions
2 x 1 Amp
Frequency
433.92 MHz
Code memorising system
Self-learning or via programmer
Memory capacity
255 codes
Access control input connection
Variolec max. 2
Aerial
Incorporated into the board
3- PROG VIA RADIO
PROG / RST
MEMORY
CHANNEL 2
CHANNEL3
RELAY 1
1- BISTABLE 1
2- BISTABLE 2
https://appceso.com
