BALER MODES
There are three basic modes of operation a downstroke vertical baler will perform
–
loading, compression, and ejection.
LOADING
Material is evenly loaded into the baler chamber while the safety charging gate and
ram are in the UP position. The baler chamber door is closed and locked.
COMPRESSION
With the safety gate down, the ram pushes the material down into the bottom of the
baler chamber area. Retainer Dogs located on baler chamber door help hold the
compressed material down while the ram travels up to the loading position,
opening the baler safety charging gate as it travels up.
EJECTION
When full bale indicator arrows on the ram face and baler frame match, the bale is
the proper size. Lift gate, unlatch and open chamber door at least 110 degrees,
slide baling wire through slots and tie off all wires.
Close feed gate by pulling it down completely.
Attach the ejector “T” hooks at back of baler to ram ejector lugs, set the
UP/DOWN switch located on baler electrical box to the UP position, press and
hold button in until the bale ejects. Keep clear of ejecting bale.
Summary of Contents for 1800HD
