4K Presentation Switcher with Soft Codec & Matrix Outputs
14
Please set the parameters of COM number, bound rate, data bit, stop bit and the parity
bit correctly, and then you are able to send command in Command Sending Area.
6.3 RS232 Command
Communication protocol:
RS232 Communication Protocol
Baud rate: 9600 Data bit: 8 Stop bit: 1 Parity bit: none
The end mark of command is “<CR><LF>”.
6.3.1 System Setting
Command
Function
Command & Feedback
Example
#HELP
Get the list of all commands
#HELP
all commands
#SET_POWER (param1)
Set device to standby mode or normal
mode.
param1 = 0, 1
0 - STANDBY MODE
1 - NORMAL MODE
#SET_POWER 0
@POWER 0
#SET_POWER 1
@POWER 1
#GET_POWER
Get device power status.
#GET_POWER
@POWER 0
@POWER 1
#GET_FIRMWARE_VER
SION
Get firmware version
#GET_FIRMWARE_VERSIO
N
@V1.x.x
#GET_RXFW_VERSION
Get RX firmware version
@RX_FW V1.x.x
#FACTORY_RESET
Factory default
#FACTORY_RESET
@FACTORY_RESET
#REBOOT
System reboot
#REBOOT
@REBOOT
#GET_STATUS
Get device status
#GET_STATUS
#SET_GUI_IP_ADDR
(param1).(param2).(para
m3).(param4)
Set GUI IP address
param1 = (0~255)
param2 = (0~255)
param3 = (0~255)
param4 = (0~255)
#SET_GUI_IP_ADDR x.x.x.x
@SET_IP
(param1).(param2).(param3).(
param4)
#GET_GUI_IP_ADDR
Get GUI IP address
#GET_GUI_IP_ADDR
@GUI_IP x.x.x.x
#SET_RS232_BAUD
Set the communication baud rate of
#SET_RS232_BAUD 0
