PTM PMO1450, Assembly Manual

Page: 25 / 36

Montageanleitung / Assembly guide
Seite 25 von 36
A.5 General safety precautions
The installation instructions are to be read by the motor operator prior to commissioning and the precautions
observed during operation.
14. The motor can be used in any position.
15. Check that all packaging and contamination protection residues have been removed.
16. Make sure that all connections and joints are correctly made.
17. The tamperproof seals must not be damaged.
18. Repairs are reserved for the manufacturer.
19. Observe Directive 1999/92/EC (employee health and safety)
20. Do not exceed the maximum operating pressure of 6 bar.
21. Minimum operating pressure is 2 bar.
22. Do not exceed the maximum motor speed of 300 rpm. Danger of total destruction.
23.
Geared motors may only be reversed if the motor is at standstill
24. Use non-oiled, dried compressed air with a filtration of <= 5µ.
25. Temperature application range is -10°C to +80°C
26. Check the delivery against your order and the delivery note with serial number for authenticity and
completeness.
Strict compliance to the accident prevention regulations and any additional national safety regulations is
required at all times.