electric radiant heater
•
To ensure optimum heat effectiveness, it is recommended that after the heater has been
used for approximately 80-100 hours, that the front glass is opened and both the front glass
and the reflector are wiped with a lint-free cloth before resealing.
•
If at any time, a white deposit is seen on the inside of the glass or on the reflector, either or
both should be cleaned with a dust-free cloth.
•
The heater is supplied with toughened safety glass. In the unlikely event that this should
become cracked, discontinue use and contact ptg|event services for a replacement.
replacing the emitter
1.
Disconnect the power supply and ensure that the emitter is not illuminated and that the heater
body and emitter are cool.
2.
Unscrew the back two screws at top of the casing – see figure 1
3.
Open hinges front cover – see figure 1
4.
IF FITTED WITH SPRING LOADED HOLDERS FOLLOW STEPS 1-3 THEN:
a.
Remove the emitter from the spring loaded holders, by pushing one end further into its
holder and pulling the end that is now free towards you. – see figure 4
b.
Refit in reverse order.