00031120.DOC, Version 1.0
20/25
4.2 Frontpanel
(1) POWER SWITCH
Press this button to start operation.
(2) CLIP-LED
This LED flashes when the output signal starts distorting.
(3) PROTECT-LED
This LED is illuminated after switching the device on as long as the speakers are not connected with the
amplifier.
If this LED is illuminated during the operation, one of the protection circuits is active. Please take the
amplifier out of operation and check it.
(4) SIGNAL-LED
The LEDs are illuminated in accordance with the adjusted signal level.
(5) POWER LED
(6) GAIN-CONTROLS
Adjust the desired volume here.
(7) VENTILATION GRILLE
4.3 Rear panel
(8) VENTILATION FAN
(9) FUSEHOLDER
(10) AC-CONNECTION
(11) LINK OUT-OUTPUT SOCKETS
(12) XLR INPUT SOCKETS
Connect the input signal here using a balanced XLR-plug.
(13) PARALLEL/DUAL/BRIDGE-MODE SELECTOR
For selecting the desired operation mode.
(14) SENSITIVITY SELECTOR
(15) LOW CUT SELECTOR
(16) GROUND LIFT-SELECTOR
(17) SPEAKER-OUTPUT SOCKETS
For connecting the speakers of channel 1 and 2.
(18) BINDING POST-OUTPUT SOCKETS
For connecting the speakers of channel 1 and 2.
(19) MONO BRIDGE-BINDING POST
For connecting the speakers in bridged mode.
