TSC 1500
14
How to assign Aux devices
:
(7)-Auxiliary device is defined as an on or off feature. The 1500 is capable of having 50 Aux
devices total. Any Device relay can be turned into an Aux relay. The power being used for this
relay must be landed in the (IN) section of the device relay terminal block. This incoming power
can be anything from 5vdc to 250v AC. It is the same process as above but other as type device
and a number in the range of 50 to 99.
How to assign Aux Groups
:
(8)-This ability allows multiple auxiliary devices to operate as one group. If a user wishes to
group two scoreboards together they would use this. Follow the same instructions for adding a
device to a group. The only difference is aux groups are 76-98
How to change pass code:
Press "8" (LED will turn Solid Yellow) then existing 4 digit code (double beep and LED will
flash yellow). Then enter new 4 digit code (4 beeps for confirmation). Keypad will go back to
locked state, enter new code to go to command mode.
Timer Note
: In any mode if no key is pressed for 30 seconds the keypad will reset and go into
the locked state.
Manual Control Override
This system has a built in over ride back up. To use this ability you must have the TSC-MC
option. This is used when plugging in the TSC-MC into the relay board at J3 and then activating
it with S1 on page 6. This will cycle through the relays that can be activated.
LED 1
LED 2
LED 3
LED 4
Device
ON
Off
Off
Off
1
Off
On
Off
Off
2
On
On
Off
Off
3
Off
Off
On
Off
4
On
Off
On
Off
5
Off
On
On
Off
6
On
On
On
Off
7
Off
Off
Off
On
8
On
Off
Off
On
9
Off
On
Off
On
10
Press S1 and watch the LED's for selection and
then use the remote to manually raise or lower.
To go back to normal operation go past 10 and
once you see the LED blinking you are back to
normal mode.
Summary of Contents for TSC 1500
