FirstGard Hinge and Band Replacement Instructions
10
FIRSTGARD
™
HINGE REPLACEMENT
Lower the
disconnected panel
(A2) between the two
banded
panels
(A1 and A3) and close all of the panels together. Align the
round barrel on the hinge components.
Assess if the current
nylon pin
(C) is intact. If the barbs or pin are
not as shown, using a 7/16” wrench, finger-tighten
weld nut
(B) on
top of the nylon pin—flange side up. Grip the flange with pliers and
tighten it an additional ¼ turn past finger-tight.
Insert the
nylon pin
(C) into the barrel of the hinge. The
weld nut
(B) should be on the top of the cone and the barbs of the nylon pin should
point towards the bottom.
Note:
Be sure the nylon pin is going through the hinge component’s
round barrel
rather than the open hinge
cavities.
STEP 9
STEP 10
STEP 11
C.
C.
B.
C.
B.
A1.
A2.
A3.
Round barrel
C.
Replace due to
missing barb
Replace due to
broken pin
Usable
