Required Accessories:
• 7mm Pen Mandrel
• Drill Bit: PKEXEC-38
• Bushing Set(2 pc): PKSPRTBU
• Barrel Trimming set: PKTRIM38 or
• Squaring Jig with 3/8” sleeve from PKTRIMSET
• Live Tailstock or Mandrel Saver
• 2 part Epoxy or Thick CA (Cyanoacrylate) Glue
• Pen Blank Minimum Size: 3/4” x 2-1/2”
#PKSPRTXX
PSI Woodworking Products
Mobile Device Support Kit
Preparing the Blank:
• Cut 1 blank to the to the length of the tube, adding 1/16” for squaring off.
• Drill 3/8” hole lengthwise through the blank.
• Spread glue over the tube, insert the tube into the blank with a twisting motion to spread the glue evenly inside.
• Center the tube lengthwise inside the blank.
• When the glue is dry, square the ends of the blanks, making sure the trimmed ends are 90º to the tube. Use a 3/8”
EDUUHOWULPPHURUDSHQEODQNVTXDULQJMLJZLWKDµVOHHYHRQDGLVFVDQGHU7DNHWKHH[FHVVPDWHULDOGRZQÁXVKWR
the ends of the tubes. Do not trim past the end of the tube since this may interfere with the operation of the
mechanism and assembly. Use a barrel trimmer to clean the inside of the tube.
Kit Features:
• Dual purpose stylus and mobile device stand with hands free viewing
• Device can be mounted horizontally or vertically
• Easy to Turn With Straight Tube
• Minimal Parts--easy to assemble
$YDLODEOHLQPXOWLSOHÀQLVKHV
• Overall Length: 3-7/16”
• Replacement stylus tips available
',$*5$0$3$576/$<287
*Do not press directly on Stylus Holder or Device Holder. See Diagram C
1.384”
Sliding Clamp
Stylus Holder*
Device Holder*
Tube/Barrel
Stylus Tip
Coupler
Top
Side
In Use
