Turning The Blanks
• Mount the bushings and blank according to Diagram B.
• Thread on the knurled nut and hand tighten to hold all components in place.
• Slide the tailstock up snugly against the mandrel shaft inserting the live center point into the mandrel dimple, lock in place.
• Hand tighten the quill adjustment to firm up the mandrel. (DO NOT overtighten, it could damage the mandrel.
• Using sharp tools, turn the blank down close to the bushing diameter. Turn the barrel (straight or to a profile of your choice)
• Sand the blank down to be flush with the bushings gradually increasing the sandpaper grits.
• Finish the barrel with your choice of polish. Allow sufficient time for the polish to cure. - refer to polish instructions.
DIAGRAM B - Turning the Blanks
© 2012 PSI Woodworking Philadelphia PA 19115 - v12/12
Assembly
• Position the bolt either in Position A or Position B. (Delivered in position A)
• Position A - Check to see if bolt is tightly in place. To tighten see Note 1
• Position B - Reverse the direction of the bolt. See Note 1 on loosening / tightening the bolt.
• Rotate the clip to slot B (press into slot)- do this by Unscrewing the Cap and rotating the clip.
• Re- attach the cap after re-positioned
NOTE: Layout Finished parts according to Diagram A
• Press the front end into either end of the barrel.
• Press the back end assembly into the opposite end of the barrel.
• Unscrew the tip and insert the refill into the opening at the front end.
• Insert the spring over the refill and replace the tip.
• Lock or unlock the bolt to extend or retract the refill tip.
PKCP80XX
PSI Woodworking Products
DIAGRAM D - Bushings
#PKCP3000BU
Blank
7mm spacer
bushings
headstock
mandrel
live
center
knurled nut
wood
barrel
End
bushing
End
bushing
7mm spacer
bushings
ø.466”
ø.466”
ø.344”
ø.344”
ø.248” hole through
Back End
Set Screw
Bolt Position A
Bolt Position B
NOTE1:
Changing and tightening the bolt.
To loosen or tighten the bolt,
loosen or tighten the set screw as
shown below in diagram C. Take
a long phillips screw driver with a
small head, insert into the back end
as shown. Rotate the bolt as nec-
essary and tighten the set screw.
DIAGRAM C
NOTE: Please do not press the front end of this kit
with the tip removed. If you do so the parts will not
assemble properly and you will void our warranty